Rod Ends Series K  -  Stainless, Maintenance Free
Series GARSW
Rod Ends with male thread made from stainless steel with PTFE liner, maintenance free










For use at high dynamic pressure and tension loads in corrosive environments
Size
(D)
B M A F L O G GL Static
load Co
kN
Dynamic
load C
kN
Limiting
speed
rev/min
Weight
g
4¹ 7 5,25 14 30 37 6,5 M 4 19 2,5 5,1 9
5 8 6,00 18 33 42 7,7 M 5 19 6,2 7,5 600 13
6 9 6,75 20 36 46 8,9 M 6 21 8,8 9,3 530 20
8 12 9,00 24 42 54 10,4 M 8 25 16,1 16,7 420 33
10 14 10,50 28 48 62 12,9 M 10 28 25,5 23,4 350 56
12 16 12,00 32 54 70 15,4 M 12 32 34,5 32,0 300 87
14 19 13,50 36 60 78 16,8 M 14 38 39,5 42,0 260 129
16 21 15,00 42 66 87 19,3 M 16 40 60,5 52,5 230 189
18 23 16,50 46 72 95 21,8 M 18x1,5 44 73,0 64,0 210 267
20 25 18,00 50 78 103 24,3 M 20x1,5 47 83,0 78,0 190 348
22 28 20,00 54 84 111 25,8 M 22x1,5 51 100,0 97,0 170 443
25 31 22,00 60 94 124 29,6 M 24x2 57 118,0 122,0 150 600
30 37 25,00 70 110 145 34,8 M 30x2 71 155,0 168,0 130 1030
35 43 28,00 80 125 165 37,7 M 36x2 73 191,0 206,0 110 1600
40 49 35,00 90 142 187 44,2 M 42x2 78 235,0 286,0 100 2570

Materials:

Housing: Stainless steel to 1.4057, Aisi 431, forged, polished
size 40 turned from stainless steel to 1.4057, Aisi 431
Insert: special high strength bronze to CuSn8 with PTFE liner bonded to the inner surface
Ball: dearing steel to 100Cr6, Aisi 52100, hardened, ground, polished, hard chrome plated on the running surface
On request: insert: stainless steel to 1.4571, Aisi 316Ti
ball: stainless steel to 1.4034, Aisi 420C hardened, ground, polished
or in stainless steel to 1.4401, Aisi 316 ground, polished
This series is also available sealed (-2RS) or with threaded bolt (-BO)
¹ Size 4 on request. Housing turned from stainless steel to 1.4305, Aisi 303

achtungneu

Please note: The dynamic load "C" of the bearing of some rod ends is in some sizes higher than the static load "Co" of the rod end.