Rod Ends Series K  -  Maintenance Free
Series GASW
Rod Ends with male thread made from free-cutting or heat-treated steel, zinc plated with PTFE liner, maintenance free










For use at dynamic loads
Size
(D)
B M A F L O G GL Static
load Co kN
Dynamic
load C
kN
Limiting
speed
rev/min
Weight
g
5 8 6,00 18 33 42 7,7 M 5 19 4,3 7,5 600 13
6 9 6,75 20 36 46 8,9 M 6 21 6,0 9,3 530 20
8 12 9,00 24 42 54 10,4 M 8 25 11,0 16,7 420 33
10 14 10,50 28 48 62 12,9 M 10 28 17,4 23,4 350 56
12 16 12,00 32 54 70 15,4 M 12 32 23,5 32,0 300 87
14 19 13,50 36 60 78 16,8 M 14 38 21,0 42,0 260 129
16 21 15,00 42 66 87 19,3 M 16 40 32,0 52,5 230 189
18 23 16,50 46 72 95 21,8 M 18x1,5 44 38,5 64,0 210 267
20 25 18,00 50 78 103 24,3 M 20x1,5 47 44,0 78,0 190 348
22 28 20,00 54 84 111 25,8 M 22x1,5 51 53,0 97,0 170 443
25 31 22,00 60 94 124 29,6 M 24x2 57 61,0 122,0 150 600
30 37 25,00 70 110 145 34,8 M 30x2 71 82,0 168,0 130 1030
35 43 28,00 80 125 165 37,7 M 36x2 73 101,0 206,0 110 1600
40 49 35,00 90 142 187 44,2 M 42x2 78 124,0 296,0 100 2570
50 60 45,00 116 185 243 55,9 M 48x2 105 308,0 458,0 80 4800

Materials:

Housing: up to size 12 turned, from free-cutting steel to 9SMnPb28K, 12L13
from size 14  forged, from heat-treated steel to C22, M1023
size 50 turned from heat-treated steel C45, Aisi 1045
Insert: free-cutting steel to 9SMnPb28K, 12L13, with PTFE liner bonded to the inner surface
Ball: bearing steel 100Cr6, Aisi 52100, hardened, ground, polished
This series is also available sealed (-2RS) or with threaded bolt (-BO)

achtungneu

Please note: The dynamic load "C" of the bearing of some rod ends is in some sizes higher than the static load "Co" of the rod end.