Rod Ends Series K  -  Stainless
Series GARS
Rod Ends with male thread made from stainless steel, regreasable through grease nipple in housing










For use in corrosive environments
Size
(D)
B M A F L O G GL Static
load Co kN
Dynamic
load C kN
Limiting
speed rev/min
Weight
g
3¹ 6 4,50 14 26 33 5,1 M 3 15 7,0 1,8 6
5¹ 8 6,00 18 33 42 7,7 M 5 19 6,2 3,3 13
6 9 6,75 20 36 46 8,9 M 6 21 8,8 4,3 1500 20
8 12 9,00 24 42 54 10,4 M 8 25 16,1 7,1 1200 33
10 14 10,50 28 48 62 12,9 M 10 28 25,5 10,0 1000 56
12 16 12,00 32 54 70 15,4 M 12 32 34,5 13,5 860 87
14 19 13,50 36 60 78 16,8 M 14 38 39,5 17,0 750 129
16 21 15,00 42 66 87 19,3 M 16 40 60,5 21,5 660 189
18 23 16,50 46 72 95 21,8 M 18x1,5 44 73,0 26,0 600 267
20 25 18,00 50 78 103 24,3 M 20x1,5 47 83,0 31,5 540 348
22 28 20,00 54 84 111 25,8 M 22x1,5 51 100,0 38,0 500 443
25 31 22,00 60 94 124 29,6 M 24x2 57 118,0 47,0 440 600
30 37 25,00 70 110 145 34,8 M 30x2 71 155,0 64,0 370 1030
35 43 28,00 80 125 165 37,7 M 36x2 73 191,0 80,0 330 1600
40 49 35,00 90 142 187 44,2 M 42x2 78 235,0 116,0 290 2570

Materials:

Housing: stainless steel to 1.4057, Aisi 431, forged, polished
size 40 made from stainless steel to 1.4057, Aisi 431, turned
Insert: special high strength bronze to CuSn8
Ball: bearing steel to 100Cr6, Aisi 52100, hardened, ground, polished, hard chrome plated on the running surface
On request: ball can be made from stainless steel to 1.4034, Aisi 420C, hardened, ground, polished
On request: insert can be made from stainless steel to 1.4301, Aisi 304, or 17-4Ph (1.4542) etc.
This series is also available sealed (-2RS) and with threaded bolt (-BO)
¹ without lubrcation fitting